Gutter © Amar Sjauw En Wa

Gutters

Download PDF

A gutter is a simple form of above ground drainage for use on streets and squares. The street profile can be identical to a conventional solution with storm drains but then without the drains and with a slightly deeper gutter.

The water draining through the gutter is transported to the surface water or infiltrated into the ground
by means of an infiltration system.

A gutter must always have a slope.

When developing a district without a rainwater sewage system but with open gutters, it is essential to take into account the slope necessary for the above ground rainwater system.

The slope of a gutter along a road can be realised if the road is constructed on a slope or the slope can be realised in a gutter with a slope. The maximum length of such a gutter is approximately 50 meters. Otherwise the gutter will get too deep and with the usual width of 30 cm and a maximum depth of more than 5 cm the gutter cannot be cleaned by street sweepers. If the gutter follows the sloped road, the slope must be at least 0.5 cm/m.

Fluted gutters

Fluted gutters have a minimal depth and gentle side slopes allowing cleaning by a road sweeper. They can be made from the same material as the pavement or are prefabricated. Prefab open gutters are often less aesthetically pleasing but easier to install. It is easier to construct connections and curves with paving bricks.

Section scheme © atelier GROENBLAUW, Marlies van der Linden

Solar City, Linz, Austria © Atelier Dreiseitl

Section scheme © atelier GROENBLAUW, Marlies van der Linden

Prefab fluted gutter © Bleijko

Open gutters

Open gutters can drain more water due to the larger possible depth and are less dependent on natural or artificial slopes. However, they cannot be cleaned with a standard road sweeper, and they can be an obstacle or a hazard for road users (prams, bicycles, etc.). This should be considered in the design phase.

You see this type of open gutters in Germany in areas with a natural slope in the landscape. Because of this they don’t need to be flushed.

Section scheme © atelier GROENBLAUW, Marlies van der Linden

Line gutter in The Hague, The Netherlands © Line gutter in Den Haag [photo by atelier GROENBLAUW, Amar Sjauw En Wa

Open gutter, Mont-Cenis, France © Atelier Dreiseitl

Covered gutters

A prefabricated gutter covered with a grate is a simple form of above ground drainage for streets and squares. The street profile can be identical to a conventional solution with storm drains but then without the drains.

The gutters can drain more water because of the greater depth and are less affected by a natural or imposed decline. Covered gutters cannot be cleaned with a regular street sweeper and must be flushed out regularly.

Because they don’t obstruct road use, covered gutters can be used in urban situations. Cyclists and pedestrians can safely cross these gutters. There are many different prefab products available on the market for covered gutters.

Section scheme © atelier GROENBLAUW, Marlies van der Linden

Bo02 Hammarby Sjöstad, Stockholm, Sweden © atelier GROENBLAUW, Madeleine d’Ersu